Take another look at the schematic. I picked up a RS IR receiver many years ago and used it to control my computer via virtually any remote. Have you ever needed a USB to RS converter to connect to your microcontroller for serial communications? Email required Address never made public. My problem now is: Thanks for marking this as the answer. I think you can be fairly confident the pad labeled 2 is indeed DTR.

Uploader: Arashidal
Date Added: 6 July 2009
File Size: 58.33 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 92918
Price: Free* [*Free Regsitration Required]

Hookup the TxD and RxD wires as shown in the schematic. In the first order I made I got a cable with an ArkMicro chip inside and a 6-wire cable and in the second order I got 4 cables with a Prolific Ussb chip and a 3-wire cable. In reality, when I look at the bottom of the board it does not appear as such.

After a Google search about “Nokia driver update”, I ended up onto a site offering a download of an updated version of Nokia PC Suite 5. However, it is possible to get power from these cables too, but bigger modifications have to be made.

I did a quick probe to confirms this, then attempted to solder the green wire to the via. The cable has a label on the USB. Wear an anti-static wrist strap. Attach the red cable to the pin 6 wire TxD.

See Also  TRAVELMATE 4020 DRIVERS

Attach the black cable to the wire which corresponds pin 8 GND. The voltages are different and the logic is inverted. After you connect the cable to the Arduino you no longer need to use Hyperterminal.

Or is there anything corrupt in my computer? Victor March 15, at 2: Nov 07, Want to watch this again later.

Stumbled upon this page while looking for info about updating the pl seems to be very little out there. You could try it and see, but you might smoke it.

The BiT Bang Theory

Take another look at the schematic. The difference is that with tp cable with the ArkMicro chip you can power the the device that you connect the cable to with 3. You should double check your work because the wires are very thin and the pins are small and close together.

The article on my blog has a bit more information e. Unfortunately the cable reports itself as a low power device.

Nokia Dku-5 Serial Cable – mattersapp

Thanks to you, now I know! The Bit Bang Theory. I was however unable to get it to recognise the cable and looking on EDA Board appears a special […].

Email required, but never shared.

See Also  MAGICOLOR 4750DN DRIVER DOWNLOAD

What version of pc suite supports a dku-5 usb cable ?

Would you suggest that I try a CA cable? Studying a picture on your computer beats the hell out of using the magnifer on a Helping Tk. If you get it to work, write back and let us know! After seril, you may close the USB housing again using some hot glue. In my case my RXD line had less than a volt going to the multimeter or a bad connection.

Most of the cable should remain attached to the USB connector, but you need to leave enough cable attached to the phone connector to be able to strip the wires and attach an alligator clip or a terminal block if you like. If you try to exceed mA, bad things can happen. This connectivity cable lets you charge your phone while transferring data to or from your PC. Now, test the connectivity with a multimeter on those pins and find out which cable goes to what pin.